I am going to move the radio to a different port today and try it tonight I aslo should of mentioned that the links are POE Radios.
>>> Jared Mauch <[email protected]> 4/26/2013 2:18 PM >>> On Apr 26, 2013, at 4:08 PM, "Mike Glass" <[email protected]> wrote: > Here is what I have been seeing on the switch side when allowing traffic to > pass, it will run for most of the day, then bam it does this. > > Apr 25 13:15:46: %LINEPROTO-5-UPDOWN: Line protocol on Interface > GigabitEthernet > 0/19, changed state to down > Apr 25 13:15:50: %LINEPROTO-5-UPDOWN: Line protocol on Interface > GigabitEthernet > 0/19, changed state to up This looks like one of the following: 1) Cabling problem to radio 2) Problem with the radio ethernet phy interface 3) Problem with the switch ethernet phy interface You can perhaps try to troubleshoot by looking at the 'show controller' command output for the interface. I don't know on this platform, but it typically reveals underlying details of the physical link layer that are not always promoted to 'show interface' outputs. >From the radio side, I would also ask you questions like: If the radio loses >link, does it promote that error to the ethernet interface? Is there a >management interface (sideband access or otherwise) that you can get details >from the radio side ethernet controller as well? - jared _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
