Hi ,
Please share us SW2 int vlan200 config.
and ping result from sw1 to sw2
On 08/09/2013 03:52 PM, Christian Kildau wrote:
Hi Cisco-NSP,
we're having some very strange issues while adding HSRP to our Nexus 5020 where
both HSRP peers are up, but don't recognize each other, thus causing some
issues.
Our config is pretty simple, running 4 VLANs and VPC. VPC is up and the Trunks
are running fine.
We now added some SVIs for L3 routing which also seems to be working fine.
But as soon as we add HSRP config as follows:
interface Vlan200
no shutdown
no ip redirects
ip address 10.8.200.2/24
hsrp version 2
hsrp 1
preempt
priority 110
ip 10.8.200.1
we're facing some very strange issues.
According to 'debug hsrp engine packet hello' both sides do send HSRP Hello
Packets, but the other end never receives them, so both peers are in Active
state:
sw1# sh hsrp group 1 brief
Interface Grp Prio P State Active addr Standby addr Group addr
Vlan200 1 110 P Active local unknown 10.8.200.1
(conf)
sw2# sh hsrp group 1 brief
Interface Grp Prio P State Active addr Standby addr Group addr
Vlan200 1 100 P Active local unknown 10.8.200.1
(conf)
What could cause this?
Thanks for any hint!
Kind Regards
Christian
P.S.
features are enabled of course ;-)
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
