Hi, then are all on the same ASIC. As a example output for WS-X6516A-GBIC and WS-X6724-SFP
Regards, Armin Kneip nc#sh int gi 1/1 cap GigabitEthernet1/1 Model: WS-X6516A-GBIC Type: 1000BaseSX Speed: 1000 Duplex: full Trunk encap. type: 802.1Q,ISL Trunk mode: on,off,desirable,nonegotiate Channel: yes Broadcast suppression: percentage(0-100) Flowcontrol: rx-(off,on,desired),tx-(off,on,desired) Membership: static Fast Start: yes QOS scheduling: rx-(1p1q4t), tx-(1p2q2t) QOS queueing mode: rx-(cos), tx-(cos) CoS rewrite: yes ToS rewrite: yes Inline power: no SPAN: source/destination UDLD yes Link Debounce: yes Link Debounce Time: yes Ports on ASIC: 1-8 Remote switch uplink: yes Dot1x: yes Port-Security: yes nc#sh int gi 2/1 cap GigabitEthernet2/1 Model: WS-X6724-SFP Type: 1000BaseSX Speed: 1000 Duplex: full Trunk encap. type: 802.1Q,ISL Trunk mode: on,off,desirable,nonegotiate Channel: yes Broadcast suppression: percentage(0-100) Flowcontrol: rx-(off,on,desired),tx-(off,on,desired) Membership: static Fast Start: yes QOS scheduling: rx-(1q8t), tx-(1p3q8t) QOS queueing mode: rx-(cos), tx-(cos) CoS rewrite: yes ToS rewrite: yes Inline power: no SPAN: source/destination UDLD yes Link Debounce: yes Link Debounce Time: yes Ports-in-ASIC (Sub-port ASIC) : 1-24 (1-12) Remote switch uplink: no Dot1x: yes Port-Security: yes On 12.09.2013 14:19, Harry Hambi wrote: > Hi Armin, > Below is the output of the sh int capabilities coomand > > Model: VS-SUP2T-10G > Type: 10Gbase-LR > Speed: 10000 > Duplex: full > Trunk encap. type: 802.1Q > Trunk mode: on,off,desirable,nonegotiate > Channel: yes > Broadcast suppression: percentage(0-100) > Flowcontrol: rx-(off,on),tx-(off,on) > Membership: static > Fast Start: yes > QOS scheduling: rx-(8q4t), tx-(1p7q4t) > QOS queueing mode: rx-(cos,dscp), tx-(cos,dscp) > CoS rewrite: yes > ToS rewrite: yes > Inline power: no > Inline power policing: no > SPAN: source/destination > UDLD yes > Link Debounce: yes > Link Debounce Time: yes > Ports on ASIC: 4 > Remote switch uplink: no > Port-Security: yes > Dot1x: yes > > Not sure I understand the output. I'me I right in saying there are 4 ports on > each Asics? > The card in question is a 5 port sup card. > > > Rgds > Harry > > Harry Hambi BEng(Hons) MIET Rsgb > > -----Original Message----- > From: cisco-nsp [mailto:[email protected]] On Behalf Of Armin > Kneip > Sent: 12 September 2013 12:10 > To: [email protected] > Subject: Re: [c-nsp] Input Errors And CRC Errors > > Hi Harry, > > show interfaces gi 7/1 capabilities > > shows the ASIC. > > > Regards, > > Armin Kneip > > > On 12.09.2013 12:51, Harry Hambi wrote: >> Hi All, >> Trying to diagnose a problem on a 6509 chasis, port showing input and >> CRC errors on one end of the link. The link is a Tengigabit I'me going to >> try the follwing: >> Change fibre >> Change Gbic, if errors are still showing try changing port. >> Change to a different port on the switch.....how do I make sure that I am >> moving to a different ASICS as well? How do I determine port/Asic mapping?, >> is there a sh command that may help?. Any help appreciated. >> >> Rgds >> Harry >> >> Harry Hambi BEng(Hons) MIET Rsgb >> >> >> >> ------------------------------------ >> http://www.bbc.co.uk >> This e-mail (and any attachments) is confidential and may contain >> personal views which are not the views of the BBC unless specifically stated. >> If you have received it in >> error, please delete it from your system. >> Do not use, copy or disclose the >> information in any way nor act in reliance on it and notify the sender >> immediately. >> Please note that the BBC monitors e-mails sent or received. >> Further communication will signify your consent to this. >> ------------------------------------ >> >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> > > -- > Mit freundlichen Grüßen / Kind regards > > Armin Kneip > > > GHOSTnet GmbH > Kaiser-Friedrich-Promenade 65 > D-61348 Bad Homburg v.d.H (Germany) > Office +49 (0) 6172 185025 > Fax +49 (0) 6172 185029 > Internet: www.ghostnet.de > eMail: [email protected] > > Sitz: Kaiser-Friedrich-Promenade 65, D-61348 Bad Homburg v.d.H. > Amtsgericht Bad Homburg v.d.H. HRB 8637, UST-ID-Nr. DE206435465 > Geschäftsführer: Sebastian Grafmüller > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > > > ----------------------------- > http://www.bbc.co.uk > This e-mail (and any attachments) is confidential and > may contain personal views which are not the views of the BBC unless > specifically stated. > If you have received it in > error, please delete it from your system. > Do not use, copy or disclose the > information in any way nor act in reliance on it and notify the sender > immediately. > Please note that the BBC monitors e-mails > sent or received. > Further communication will signify your consent to > this. > ----------------------------- > -- Mit freundlichen Grüßen / Kind regards Armin Kneip GHOSTnet GmbH Kaiser-Friedrich-Promenade 65 D-61348 Bad Homburg v.d.H (Germany) Office +49 (0) 6172 185025 Fax +49 (0) 6172 185029 Internet: www.ghostnet.de eMail: [email protected] Sitz: Kaiser-Friedrich-Promenade 65, D-61348 Bad Homburg v.d.H. Amtsgericht Bad Homburg v.d.H. HRB 8637, UST-ID-Nr. DE206435465 Geschäftsführer: Sebastian Grafmüller _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
