Randy How do I change the dynamic time out ? Renelson
> On Sep 29, 2013, at 4:23 PM, Randy <[email protected]> wrote: > > you are performing PAT and dynamic translations timout after a period of > non-use. > IIRC on router IOS the defaults are: > 24 hrs for tcp unless a rst or fin is seen > non-dns udp is 5 mins; dns: 1 min > Only static entries remain indefinitely - as long as it is present in config. > ./Randy > > > > > > >> ________________________________ >> From: Renelson Panosky <[email protected]> >> To: [email protected] >> Sent: Sunday, September 29, 2013 12:17 PM >> Subject: [c-nsp] IP nat translation >> >> >> How do i restore IP nat and the IP NAT translation table ? they are not >> showing on my IP nat translation.. >> >> here are my configuraation.. >> ip nat inside source list 1 interface GigabitEthernet0/1 overload >> >> route-map NAT_1 permit 1 >> match ip address 1 >> match interface GigabitEthernet0/1 >> ! >> access-list 1 permit 10.10.0.0 0.0.255.255 >> >> sho ip nat translation >> Pro Inside global Inside local Outside local Outside global >> udp 164.XX.XX.XX:12134 10.XX.XX.X:12134 10.XX.XX.XX:12134 >> 10.XXX.XX.XX:12134 >> >> the translation would show on the table for sometimes and dispear.. >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> >> >> _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
