Have you tried to remove all portchannel config.

Shutdown all ports. Then only enable the ports you got a problem with ?

Or try with the ports that work and then add the other ports and check
the logs ??

Jey S.
Network Engineer

Sent from my iPhone

> On 18 Nov 2013, at 12:27, M K <[email protected]> wrote:
>
> I have Cisco CISCO7606-S (R7000) with 48  SFM-capable 48 port 10/100/1000mb 
> RJ45 moduleNow , I have 5 ports connected to my WiMAX ASN gateway via two 
> vlans one to the access side and the other one connected to the core sideThe 
> issue am facing now is some of the ports are into errdisable state by itself
> Module diagnostics output   3  Pass
> Group  Port-channel  Protocol    
> Ports------+-------------+-----------+-----------------------------------------------10
>      Po10(SU)         -        Gi3/3(D)    Gi3/11(D)   Gi3/19(D)              
>                       Gi3/27(P)   Gi3/35(P)   20     Po20(SU)         -       
>  Gi3/4(D)    Gi3/12(D)   Gi3/20(D)                                    
> Gi3/28(P)   Gi3/36(P)
> CR2.KJ-Building#sh int Gi3/3 | inc lineGigabitEthernet3/3 is down, line 
> protocol is down (err-disabled)
> interface GigabitEthernet3/3 description ASN LBPA0 C6 P5 (Po10) (CORE_VLAN) 
> switchport switchport access vlan 10 switchport mode access no logging event 
> link-status load-interval 30 speed 1000 duplex full flowcontrol receive on 
> flowcontrol send on channel-group 10 mode on
> CR2.KJ-Building#sh run int vlan 10Building configuration...
> Current configuration : 242 bytes!interface Vlan10 description CORE VLAN ip 
> address 10.40.2.3 255.255.255.240 no ip redirects no ip unreachables 
> load-interval 30 standby 10 ip 10.40.2.1 standby 10 priority 120 standby 10 
> preempt standby 10 name CORE_VLAN_HSRP
> The configuration for the physical port is identical for all ports , no log 
> messages give a clue that there is a problemNow , if i enabled those 
> interfaces again , I lose the device until I restart the module again
> No spanning-tree issues were noticed , I have checked everything !
> What could cause this?
> Thanks
> _______________________________________________
> cisco-nsp mailing list  [email protected]
> https://puck.nether.net/mailman/listinfo/cisco-nsp
> archive at http://puck.nether.net/pipermail/cisco-nsp/

_______________________________________________
cisco-nsp mailing list  [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/

Reply via email to