Thank you guys for your reply. I dont have SVI in my current config, all the G.Ws are configured under physical interfaces. I have 3 trunk links to 3560 SW, sub-interfaces + VLANs.
On Mon, Dec 2, 2013 at 8:39 PM, Peter Rathlev <[email protected]> wrote: > On Sun, 2013-12-01 at 23:44 +0300, Ahmed Hilmy wrote: > > Kindly, I have 7606 chassis with SUP32 IP/MPLS , I want to replace the > > chassis with same same type so I will turn off the old chassis then > > plug out the SUP32 from old chassis and plug in to the new chassis > > then pore on the new chassis. > > > > So once I turn on the new chassis , the service will be recovered > > normally? > > > > The new chassis has been tested with SUP720. > > This should work fine. Any chassis that will take a Sup720 will also > take a Sup32. > > Keep in mind that MAC addresses for e.g. SVIs ("interface Vlan<n>") are > taken from the chassis pool, which can be viewed with "show catalyst6000 > chassis-mac-addresses". If the device functions as a gateway the gateway > MAC address might change. Same goes for IPv6 EUI-64 addresses and STP > bridge identifiers; the latter might be of concern if the root bridge > was elected using the MAC addresses as a tie breaker, though this would > probably mean you have other problems as well. :-) > > Unless you have configuration that specifically refers to the current > MAC addresses you should be fine. > > -- > Peter > > > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
