On Sunday, March 16, 2014, PlaWanSai RMUTT CPE IX <[email protected]> wrote:
> Why doesn't CRS-1 share power load? > > > > RP/0/RP0/CPU0:cm-1(admin)#sho env pow > > Power Supply Voltage Current > > DC-PEM DC-PEM (V) (A) > > Zone 1: [A], [B] 53.005, 54.083 3.238, 10.968 > > Zone 2: [A], [B] 52.614, 53.887 3.133, 10.655 > > Zone 3: [A], [B] 53.397, 53.789 2.924, 10.341 > > > > Total Current: 41.259 A > > Total Power : 2216.183 W > > > > RP/0/RP0/CPU0:cm-1(admin)# > > > > From the output, why does source A used 3 A while source B used 10 A? It is load sharing but your B voltage is basically a full volt higher than your A - load share on those seems to be basically via diodes so the slightly higher voltage source will get a larger share of the load. You should always provision as if 100% of the load will be on one feed or the other. It's primarily there for redundancy not load share. > > > > Thank you very much. > > _______________________________________________ > cisco-nsp mailing list [email protected] <javascript:;> > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- "Genius might be described as a supreme capacity for getting its possessors into trouble of all kinds." -- Samuel Butler _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
