putting the pppoe on the svi will work however... Depending on what speed your NBN service is the router might not push the speed your after. You really need an 881... Andrew is right.
On 8 April 2014 11:28, Andrew Jones <[email protected]> wrote: > Ideally you'd use a router with an ethernet router port, and then config > will depend on how the service is being handled by the wholesaler. > It might be as simple as a vlan with an ip address on it, and an access > port in that vlan connected to the NBN NTD. > > Some wholesalers (iSeek, AAPT) require your router to act as a PPPoE > client, in which case on an 887 you'd need to put the pppoe-client command > on the SVI, rather than the physical port (even though it will accept the > config). > > > > > > On 08.04.2014 11:09, Ali Sumsam wrote: > >> Hi All, >> >> Any experience of NBN connection on a Cisco 887M, 887VA router? >> >> I am looking for a valid configuration. >> >> Regards, >> >> *Ali Sumsam - *eintellego Networks Pty Ltd >> Senior Network Engineer >> [email protected] ; www.eintellegonetworks.com >> >> Phone: 1300 239 038; Cell +61 (0)450 609 592 ; skype://sumsam.ali80 >> >> facebook.com/eintellegonetworks ; <http://twitter.com/networkceoau> >> linkedin.com/in/alisumsam >> >> >> The Experts Who The Experts Call >> Juniper - Cisco - Cloud >> _______________________________________________ >> cisco-nsp mailing list [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-nsp >> archive at http://puck.nether.net/pipermail/cisco-nsp/ >> > > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ > -- Regards, Bruce _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
