Hi, For transit traffic, I don't see any issue so far. Currently I only see high packet drop on its IPv4 loopback address. I've tried to ping the both router's loopback addresses (IPv4 and IPv6), I only see packet drop on IPv4 address. I've also checked traffic flow, I don't see any abnormal traffic beside our local SNMP and BGP ports active on the interface. I'm going to reboot the router tomorrow and let see the result. thanks
Vannara On Sat, May 3, 2014 at 7:41 PM, Gert Doering <[email protected]> wrote: > Hi, > > On Sat, May 03, 2014 at 02:23:13PM +0700, vannara vuth wrote: > > I'm also facing the similar issue. What was symtom on your router when > > receiving the log message? Packet loss to v4 address on loop back as > well? > > If you run into MLS CEF exception mode, some of your v4 traffic will > be software switched, *and* subject to MLS rate limiters - so you'll > see heavy packet loss on transit traffic to *some* destinations. > > Unfortunately the only way to clear the exception is to reboot. > > gert > -- > USENET is *not* the non-clickable part of WWW! > // > www.muc.de/~gert/ > Gert Doering - Munich, Germany > [email protected] > fax: +49-89-35655025 > [email protected] > _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
