I've been using OpenGear devices with great results. Their ACM5500 is far better than the older 5000 series units because it now does LTE instead of only 3G. It has eight serial ports and they are wired so you can run ethernet directly into Cisco console ports. It comes with, and they sell, connectors so you can do the same to standard 9-pin ports; so much easier than finding a serial cable during a crisis.
That being said, I have not had good results with the included rubber antenna when used inside a rack in a data center. The performance was very slow because the received signal strength was too low; same issue I had with the 3G units. I now purchase the WMM-7-27-5SP antenna from wpsantennas.com with my ACM5500's; it's a single mount but dual antenna uni-directional unit that I can mount up above the equipment racks and I get awesome signal strength. On the Verizon side, you just have to get your sales rep to assign a static IP and your'e good to go with ssh and vpn to your equipment. David -----Original Message----- From: cisco-nsp [mailto:[email protected]] On Behalf Of CiscoNSP List Sent: Monday, September 01, 2014 9:53 PM To: [email protected] Subject: [c-nsp] OOB Device for remote DC's Hi Everyone, We historically have just used Cisco 2511's with standard modem attached, but are finding it increasingly difficult to source modems - Can anyone recommend an alternative(reliable) OOB device? (Built in modem + 4G as backup?) Cheers. _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
