You may want to check the EEM Applet to TCL convertor that was written by Joe Clarke: http://www.marcuscom.com/convert_applet/
Arie -----Original Message----- From: cisco-nsp [mailto:[email protected]] On Behalf Of M K Sent: Wednesday, September 3, 2014 04:01 To: [email protected] Subject: [c-nsp] Cisco IOS XR EEM Hi , I have the below EEM script and am trying to do it using IOS XR event manager applet SLA_OUT event snmp oid 1.3.6.1.4.1.9.9.42.1.2.9.1.6.2 get-type exact entry-op eq entry-val 1 exit-op eq exit-val 2 poll-interval 5 action 1.0 syslog msg "Test" action 1.1 cli command "enable" action 1.2 cli command "configure terminal" action 1.3 cli command "ip route 0.0.0.0 0.0.0.0 192.168.13.3" action 1.4 syslog msg "There is a problem on our Primary connection , move all the traffic to the Secondary Line" event manager applet SLA_OK event snmp oid 1.3.6.1.4.1.9.9.42.1.2.9.1.6.2 get-type exact entry-op eq entry-val 2 exit-op eq exit-val 1 poll-interval 5 action 1.0 syslog msg "OK" action 1.1 cli command "enable" action 1.2 cli command "configure terminal" action 1.3 cli command "no ip route 0.0.0.0 0.0.0.0 192.168.13.3" action 1.4 syslog msg "Our Primary connection is functionin again , stop using the Secondary Line" _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
