Hello Ytti, I have checked the Lucent GBE card and the current revision is V02.04.81. The card is ISA-ES16-2.4
. Thanks! > From: [email protected] > To: [email protected]; [email protected] > Date: Fri, 24 Oct 2014 12:59:52 +0200 > Subject: Re: [c-nsp] ME3600 FCS packet generation issue > > > We've seen firmware fault in Lucent GBE card in revision S1:7, rev 3 and > > rev 6 > > work fine. This fault causes FCS occasionally to be incorrect, but you > > should > > then observe the FCS error in ME3600 itself. > > > > It would seem to me much more likely that fault would be in SDH, since > > usually > > EoSDH does not transport FCS but optimizes it away. But again, if I > > understood > > your topology correctly, error should be visible in ME3600 counters in > > interface facing SDH, not in X. > > I agree. > > Also, instead of reloading the ME3600, try just bumping the interface on the > ME3600 (shut/no shut). This will generate the same signalling in the SDH > network, > as a reload. > > If the origin of the problem is the SDH network, bumping the interface > shut have (in theory) the same effect as reloading. > > > Lukas > _______________________________________________ > cisco-nsp mailing list [email protected] > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
