The hardware replacement went rather swimmingly and does appear to have resolved our issue(s). The RSP synchronized to the active RSP. We did have to perform a couple of FPD/FPGA updates not the 100Gbps card; this went without issue. Can you verify that you have received the RMA¹d hardware?
EM On 10/30/14, 9:06 AM, "Deric Kwok" <[email protected]> wrote: >Hi > >I configure the access rule to put it in access-group in interface >to prevent to use our network to attack outside > >I can see the "matches" in access-list > >Extended IP access list attack > 30 deny udp any eq 1910 any eq 123 (124061 matches) > 500 permit ip any any (615041 matches) > > >but when I add new rule and unbind the old access-group in interface and >bind the new access-group > >Why don't have any matching in the access-list > >Extended IP access list attack2 > 40 deny udp any eq 1910 any > 500 permit ip any any > >In addition, what is different between > >ip access-group attack2 in >and >ip access-group attack2 out > >Thank you >_______________________________________________ >cisco-nsp mailing list [email protected] >https://puck.nether.net/mailman/listinfo/cisco-nsp >archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
