Hi, A customer of ours needed to extend a rack's switch ports, which at that point consisted of a stack of two 2960S-LPD-L switches. The new switch he set up was a 2960X-LPD-L. Anyway, contrary to what I would have expected, neither of the stacking ports on the S and X switches came up. As the S switches had a rather old 12.2 IOS, I did an update to the recommended 15.0 SE IOS, which again didn't give me any stacking ports in state up. Asking around, somebody confirmed they had a mixture of S and X switches, albeit with an EX train of the IOS. So, I again updated the S' IOS to the current ED release of the EX train, but still neither of the switches' stacking even showed any positive change.
Is there anything our customer could be doing wrong, or anything I need to watch out for as far as configuration goes? I even tried to manually provision the X switch on the stack, still no improvement ... Tnx, -garry _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
