Hi Experts,
I have a setup as below
Cisco ASR9k1(vrf OM_InBand_CE) ------------OSPF(loopback
cable)-----------------(vrf OM_InBand_TME_PE ) ASR9K1 (vrf OM_InBand_TME_PE)
-------------eBGP----------- ISP
For outbound:
I have one specific route x.x.x.x/23 learned by OSPF in vrf OM_InBand_TME_PE
from vrf OM_InBand_CE.
I want to send this specific route under specific vrf (normal vrf unicast) to
my eBGP peer and I am not able to do it.
Below are configurations for outbound traffic:
prefix-set to-tele
x.x.x.x/23
end-set
!
route-policy to-telepeer
if destination in to-tele then
done
endif
end-policy
!
router bgp 65201
bgp router-id x.x.x.x
address-family ipv4 unicast
!
address-family vpnv4 unicast
!
vrf OM_InBand_TME_PE
rd auto
address-family ipv4 unicast
!
neighbor y.y.y.y
remote-as 65200
address-family ipv4 unicast
route-policy to-telepeer out
soft-reconfiguration inbound always
And then check results using command "show bgp vrf OM_InBand_TME_PE neighbors
y.y.y.y advertised-routes" and nothing is going to the neighbor.
For inbound:
Similarly for inbound traffic I have to accept a default route from my eBGP
peer which is being accepted successfully by configurations below but I need
specific acceptance of default route.
For inbound I have applied below policy which is accepting everything I
believe. (neighbor is advertising one route to ASR9k1)
route-policy from-telepeer
pass
end-policy
router bgp 65201
bgp router-id x.x.x.x
address-family ipv4 unicast
!
address-family vpnv4 unicast
!
vrf OM_InBand_TME_PE
rd auto
address-family ipv4 unicast
!
neighbor y.y.y.y
remote-as 65200
address-family ipv4 unicast
route-policy from-telepeer
soft-reconfiguration inbound always
Kindly assist with your expertise if possible and point out my mistake
especially for outbound traffic where nothing is working.
Thanks and Regards,
Ahmed
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
