Nick, May be I didn't clear myself but tunnel are not on 7600 Router. Tunnel are between CE1 and CE2.
CE1=======>7600=======> CE2 CE1 is cisco 1800 series router. Here is the config on 7600 Router: 7600 Router: ip vrf NMS rd 38712:14 route-target export 38712:14 route-target import 38712:14 mpls label protocol ldp mpls ldp graceful-restart mpls traffic-eng tunnels mls flow ip interface-full no mls flow ipv6 mls nde sender version 5 mls rate-limit all ttl-failure 70000 150 mls rate-limit all mtu-failure 50000 150 mls cef error action reset mls mpls recir-agg mls mpls tunnel-recir interface GigabitEthernet2/1.14 description ** NMS-DATA-L3VPN-VID14 ** encapsulation dot1Q 14 ip vrf forwarding NMS ip address 172.100.50.33 255.255.255.252 secondary ip address 172.100.50.65 255.255.255.224 no ip redirects no cdp enable interface GigabitEthernet2/3.14 description ** NMS-DATA-L3VPN-VID14 ** encapsulation dot1Q 14 ip vrf forwarding NMS ip address 172.100.50.41 255.255.255.252 router bgp 38712 address-family ipv4 vrf NMS redistribute connected exit-address-family On Thu, Dec 15, 2016 at 5:47 PM, Nick Hilliard <[email protected]> wrote: > Shoaib Farhan wrote: > > If someone have any other ideas please share with me. > > do any of these tunnels share the same tunnel source ip address on the > 7600? They should all have different tunnel source IP addresses. > > Nick > -- Regards, Md. Shoaib Farhan <http://www.telnet.com.bd> _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
