Thanks Alan,, Do you have any documentation on how to do it?...maybe you could point me in the direction. Alan so you can number a switch before adding to a stack?.
Rgds Harry Harry Hambi BEng(Hons) MIET Rsgb -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: 03 March 2017 11:47 To: Harry Hambi - Atos Cc: '[email protected]' Subject: Re: [c-nsp] 3750 Stack Auto Upgrade Hi, > Has anyone one successfully upgraded stacks with the auto upgrade feature?. > If a member of a stack failed it would be nice if when replacing the failed > unit it would be automatically upgraded from the master. When I say upgraded > I mean the IOS and the configuration, is this possible. Any advice > appreciated. yes - new member with old firmware upgraded and then given its correct config by the master one thing to be aware of, if you are just dropping in a new fresh switch, then the stack will see it as that...and make it a new member,,,, ensure that the switch you are adding has been numbered first. alan ----------------------------- http://www.bbc.co.uk This e-mail (and any attachments) is confidential and may contain personal views which are not the views of the BBC unless specifically stated. If you have received it in error, please delete it from your system. Do not use, copy or disclose the information in any way nor act in reliance on it and notify the sender immediately. Please note that the BBC monitors e-mails sent or received. Further communication will signify your consent to this. ----------------------------- _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
