On Fri, 5 May 2017, Drew Weaver wrote:
We had a PSU failure in a 6513 and we want to replace the failed one
(which is a: WS-CAC-4000W) but currently what we have in stock is a
whole lot of these: WS-CAC-6000W
I know that it should be possible to run a switch with two different
sized power supplies (because it would make upgrading possible) but are
there any known caveats to this?
Scratch that last message. Helps if I take time to read :) I misread
that as you had a failed 6000 watt PSU and needed to replace it with a
4000 watt unit.
Other than the switch complaining about mismatched power supplies, you
should be OK. You're running 208 volt power, correct?
jms
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
