I am not sure if this is possible. I have an ISR1111 (IOS XE, 16.8)
And I have a working service instance bridging the two WAN ports interface GigabitEthernet0/0/0 no ip address negotiation auto service instance 901 ethernet encapsulation untagged bridge-domain 901 interface GigabitEthernet0/0/0 no ip address negotiation auto service instance 901 ethernet encapsulation untagged bridge-domain 901 I want to connect these two WAN ports to the switching module / WLAN module Which has a switchport config, not a routed port config interface Wlan-GigabitEthernet0/1/4 switchport trunk native vlan 600 switchport trunk allowed vlan 600,692,901 switchport mode trunk or: interface GigabitEthernet0/1/1 switchport access vlan 901 switchport mode access spanning-tree portfast I cannot seem to connect the L3 BDI 901, or use a traditional SVI to "tap into" the L2 vlan 901 I was hoping to use: interface GigabitEthernet0/0/0 service instance 901 ethernet encapsulation untagged rewrite ingress tag push dot1 901 but the command will not complete, even though it question marks to a <cr> % Ambiguous command: "rewrite ingress tag push dot1 901 " ROUTER(config-if-srv)#rewrite ingress tag push dot1 901 ? <cr> <cr> Anyone else have any ideas? _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
