I have added an ASR920 to my network and cannot get an MPLS VC to work
between it and my ASR9K. The VC comes up on both sides, but no traffic
passes through the circuit. Both the ASR9K and the ASR920 have MPLS VCs
working with other devices.
ASR9K:
Cisco IOS XR Software, Version 6.6.2[Default]
interface TenGigE0/0/1/0.95 l2transport
encapsulation dot1q 95
mtu 9114
l2vpn
xconnect group mpls1
p2p test1
interface TenGigE0/0/1/0.95
neighbor ipv4 10.100.66.1 pw-id 95
ASR920:
Cisco IOS XE Software, Version 03.18.05.SP.156-2.SP5-ext
interface TenGigabitEthernet0/0/25
mtu 9100
no ip address
cdp enable
service instance 95 ethernet
encapsulation dot1q 95
l2vpn xconnect context test1
member TenGigabitEthernet0/0/25 service-instance 95
member 10.100.25.11 95 encapsulation mpls
Local interface: Te0/0/25 up, line protocol up, Eth VLAN 95 up
Interworking type is Ethernet
Destination address: 10.100.25.11, VC ID: 95, VC status: up
VC statistics:
transit packet totals: receive 43471, send 0
I have tried both with and without a rewrite on each side, with no
difference.
Ideas, thoughts, suggestions are welcome.
Thanks.
--
Jerry Bacon
Senior Network Engineer
StarTouch, Inc.
http://www.startouch.com
360-543-5679 ext. 111
Microwave - Fiber Optics - Internet Services
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
