I swapped the connections on the 2 PRI cards this morning, and the error follows the circuit. So, I'm almost 100% sure that it's a Telco problem, and time to deal with BT. Wish me luck.
Thanks everyone, Hefin -----Original Message----- From: Hefin James [ahj] Sent: 02 April 2014 07:08 To: [email protected] Subject: RE: [cisco-voip] Requested circuit/channel not available I've got 2 isdn cards in the gateway, and before things get busy this morning, I'm going to swap connections to see if the fault follows the connection, or stay with the PRI card. Details of the current output shown below. show isdn status %Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 0. Layer 3 output may not apply ISDN Serial0/0/0:15 interface dsl 0, interface ISDN Switchtype = primary-net5 L2 Protocol = Q.921 0x0000 L3 Protocol(s) = CCM MANAGER 0x0003 Layer 1 Status: ACTIVE Layer 2 Status: TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED Layer 3 Status: 0 Active Layer 3 Call(s) Active dsl 0 CCBs = 0 The Free Channel Mask: 0xFFFF7FFF Number of L2 Discards = 0, L2 Session ID = 16 show isdn service %Q.931 is backhauled to CCM MANAGER 0x0003 on DSL 0. Layer 3 output may not apply ISDN Se0/0/0:15, Channel [1-31] Configured Isdn Interface (dsl) 0 Channel State (0=Idle 1=Proposed 2=Busy 3=Reserved 4=Restart 5=Maint_Pend) Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 State : 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 3 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 Service State (0=Inservice 1=Maint 2=Outofservice 8=MaintPend 9=OOSPend) Channel : 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 State : 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 2 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 Thanks, Hefin ________________________________________ From: Mehtab Shinwari [[email protected]] Sent: 02 April 2014 01:41 To: Hefin James [ahj]; [email protected] Subject: RE: [cisco-voip] Requested circuit/channel not available James, Whats "sh isdn q931 status" showing?. Do a "show isdn status" this will show which channels are open and which ones are out of service. If you have some channels up and its mission critical you can always busy out the "bad" channels effectivily making a customized fractional pri And yes do engage the vendor at this point. A shut no shut on the isdn interface would not hurt at this point either. Regards Mehtab Shinwari | CCNP RS/V Senior Support Engineer -------- Original message -------- From: "Hefin James [ahj]" <[email protected]> Date: To: [email protected] Subject: [cisco-voip] Requested circuit/channel not available Hi, Started to get this issue this morning with one of our MGCP gateways. Incoming calls are working correctly on an ISDN30, but outgoing calls are being denied, and re-routed via a backup route. Outgoing calls are hitting the gateway, but is getting a 'Requested circuit/channel not available' See trace below. I've tried to change the channel selection order, but still the same. I've checked everything that I can think of, and I'm beginning to think that this is a Telco issue, but thought that I'd ask the group to see if there is anything else to check before I take it up with BT. Thanks, Hefin 2014-04-01 22:07:55 local3/7 Apr 1 21:07:54.602: ISDN Se0/0/0:15 Q931: TX -> SETUP pd = 8 callref = 0x0004 2014-04-01 22:07:55 local3/7 Sending Complete 2014-04-01 22:07:55 local3/7 Bearer Capability i = 0x8090A3 2014-04-01 22:07:55 local3/7 Standard = CCITT 2014-04-01 22:07:55 local3/7 Transfer Capability = Speech 2014-04-01 22:07:55 local3/7 Transfer Mode = Circuit 2014-04-01 22:07:55 local3/7 Transfer Rate = 64 kbit/s 2014-04-01 22:07:55 local3/7 Channel ID i = 0xA9839F 2014-04-01 22:07:55 local3/7 Exclusive, Channel 31 2014-04-01 22:07:55 local3/7 Calling Party Number i = 0x0081, '2456' 2014-04-01 22:07:55 local3/7 Plan:Unknown, Type:Unknown 2014-04-01 22:07:55 local3/7 Called Party Number i = 0x80, '622456' 2014-04-01 22:07:55 local3/7 Plan:Unknown, Type:Unknown 2014-04-01 22:07:55 local3/7 Apr 1 21:07:54.682: ISDN Se0/0/0:15 Q931: RX <- RELEASE_COMP pd = 8 callref = 0x8004 2014-04-01 22:07:55 local3/7 Cause i = 0x82AC - Requested circuit/channel not available _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
