nothing for inbound Jorge Rodriguez, CCNP, CCNP-V Senior Voice/Data Network Consultant Netxar Technologies, a Digicel Company Cel 7876888530 Office 7877650058 jorge.rodrig...@netxar.com<mailto:jorge.rodrig...@netxar.com>
On Jan 26, 2015, at 8:23 AM, Reto Gassmann <v...@mrga.ch<mailto:v...@mrga.ch>> wrote: Hello Group we run a CUCM Cluster 9.1(2) with a SIP Trunk (CUBE) to our telephony provider. Our cluster has 8 Servers (1 Pub / 7 Sub). On the CUBE we have three dialpeers pointing to three different subs for redundancy: dial-peer voice 1000 voip destination-pattern session target ipv4: Server5 dial-peer voice 1001 voip destination-pattern session target ipv4: Server4 dial-peer voice 1002 voip destination-pattern session target ipv4: Server3 On the UCM we have a SIP Trunk configured with a device that contains Server3, Server4 and Server5 in its CUCM Group. All IP Phones register to Server4 or Server5. We now have the problem that Server4 has sometimes a pretty high CPU load (Code yellow). I want to change the dialpeers on the CUBE so that they point to Server7 and Server8 to reduce the load on Server4. What do we have to change on the UCM if we change the dial-peer voice 1000 and 1001 on the CUBE to dial-peer voice 1000 voip destination-pattern session target ipv4: Server7 dial-peer voice 1001 voip destination-pattern session target ipv4: Server8 Thanks a lot Regards Reto _______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net<mailto:cisco-voip@puck.nether.net> https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip