Why do we include a # for international? On 14/02/2015 8:06 AM, "Brian Meade" <[email protected]> wrote:
> If your route pattern is 9.011!#, users have to dial the # at the end to > match and your discard should be pre-dot trailing hash. Usually you'll > have 2 RPs for international (9.011! and 9.011!#). > > On Fri, Feb 13, 2015 at 3:29 PM, Ryan Huff <[email protected]> wrote: > >> Try this one on; >> >> Was working fine ... >> >> Standard Int'l route pattern 9.011!# Discard set to PreDot (again, this >> was working ... no issue on gateway ... etc) >> >> So today it stops working, just rings busy. I debug the ISDN and it shows >> called party as the last 7 digits. I go over to DNA and use an int'l >> pattern with the css I was using and it blocks pattern for unallocation. >> >> I create a new test partition with a new 9.011!# pattern in it and a new >> css with only the new partition in it. I go back over to DNA and try the >> int'l pattern with the new test css and it blocks for unallocated. >> >> Now I scratch my head, so I take off the octothorpe on the pattern >> (9.011!) and BOOM, DNA routes and everything is happy. I move to production >> and it works just fine without the octothorpe. >> >> What does this sound like? Do you think I may have competing patterns >> somewhere in the dial plan? >> >> Thanks, >> >> Ryan >> >> _______________________________________________ >> cisco-voip mailing list >> [email protected] >> https://puck.nether.net/mailman/listinfo/cisco-voip >> >> > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
