When doing CME as SRST, you need to change the default dial-peer hunt configuration to "dial-peer hunt 2" to check preference before longest match. Then add "preference 9" to your voice hunt-group configuration.
On Fri, May 8, 2015 at 11:50 AM, Nick <[email protected]> wrote: > Hi All > > I have an issue with SIP SRST on a branch router, the branch in question > has a single number coming into the gateway which is translated to 13500, > this is sent to the CUCM's dial-peers and to a hunt pilot in CUCM. > > If i set the 13500 as the pilot on the voice hunt-group, then the inbound > call failed to go to the CUCM dial-peers and tried to go to the pilot on > the voice hunt-group instead so i had to remove the 13500 pilot for calls > to work. > > In SRST, if i added the 13500 back on the voice hunt-group then the > inbound calls work fine and ring round the hunt group, to try and resolve > this in both SRST and normal mode, i have tried to translate 13500 to > 7016499 and set 7016499 as the pilot then added an alias to the voice > register pool, however in SRST the call still does not get to the hunt > pilot, if i change the translation for 13500 to go to the DN of one of the > numbers of the phones in SRST this works fine. > > Any idea how I can get the pilot to recieve the inbound call? > > Relevant config below > > ! > voice register global > system message Backup SRST Active > max-dn 35 > max-pool 35 > ! > voice register pool 1 > translation-profile outgoing SIP-TRANSLATE > id network 10.5.16.0 mask 255.255.255.0 > alias 1 13500 to 7014699 > voice-class codec 1 > ! > ! > voice hunt-group 1 parallel > final 7016450 > list 7016411,7016412,7016413,7016430,7016450 > timeout 120 > pilot 7016499 > ! > ! > ! > ! > voice translation-rule 100 > rule 1 /290290/ /13500/ > rule 2 /241430/ /13500/ > ! > ! > voice translation-rule 110 > rule 1 /13500/ /7016499/ > ! > > ! > voice translation-profile SIP-TRANSLATE > translate called 110 > ! > ! > dial-peer voice 3 voip > tone ringback alert-no-PI > description *** FIRST CCM NODE *** > destination-pattern 13... > progress_ind setup enable 3 > progress_ind alert enable 8 > session target ipv4:10.10.10.10 > voice-class codec 1 > voice-class h323 1 > dtmf-relay h245-alphanumeric > fax rate disable > ip qos dscp cs3 signaling > no vad > ! > Regards > > Nick > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
