Tried that and that doesn't work either. The phone is not registering. That's why I was trying to get into the menu of the phone to see what it was getting IP wise, etc. Another phone on same switch port works fine.
On Thu, May 4, 2017 at 10:26 PM, Brian Meade <[email protected]> wrote: > Yea, I'd just set it to something and reset the phone. I'm not sure what > the default is. > > On Thu, May 4, 2017 at 6:33 PM, Erick Bergquist <[email protected]> wrote: >> >> The local phone unlock password is blank. >> >> It stops at 4 characters when "Cisco" is tried and we tried 1234 and >> it stopped taking characters after 3 were entered. >> >> We factory defaulted it twice using proper procedure (saw correct >> light sequence) and same boat. >> >> Attached is a picture. >> >> >> >> On Fri, Apr 28, 2017 at 11:10 AM, Brian Meade <[email protected]> wrote: >> > Seeing this issue too. It looks like you can set it at "Local Phone >> > Unlock >> > Password" on the common phone profile but no idea what the default is >> > and >> > not seeing anything online. >> > >> > On Thu, Apr 27, 2017 at 9:39 PM, Erick Bergquist <[email protected]> >> > wrote: >> >> >> >> CUCM. Other phones work fine on the same switch port and cable, so >> >> that has been checked. Normal switchport config. >> >> >> >> Unable to check settings or network info on phone itself as it is >> >> prompting for this password even after factory reset. >> >> >> >> >> >> On Thu, Apr 27, 2017 at 4:34 PM, Anthony Holloway >> >> <[email protected]> wrote: >> >> > Kind of funny that I have to ask this on Cisco-VoIP now but are you >> >> > registering to CUCME, BE4K, Spark or CUCM? If CUCM, via MRA? >> >> > >> >> > Also, I've deployed many 8800 and have never seen a password issue >> >> > like >> >> > this. Albeit, most of my deployments were with CUCM. >> >> > On Thu, Apr 27, 2017 at 5:08 PM Erick Bergquist <[email protected]> >> >> > wrote: >> >> >> >> >> >> Havng issue getting new 8861 registered. >> >> >> >> >> >> On the phone it prompts for admin password, but stops at the 4th >> >> >> character. >> >> >> Default password is Cisco but we can only enter 4 characters. >> >> >> Doesn't >> >> >> take anything past 4. >> >> >> >> >> >> Anyone seen this before? >> >> >> >> >> >> Have done factory reset to with same. >> >> >> >> >> >> Erick >> >> >> _______________________________________________ >> >> >> cisco-voip mailing list >> >> >> [email protected] >> >> >> https://puck.nether.net/mailman/listinfo/cisco-voip >> >> _______________________________________________ >> >> cisco-voip mailing list >> >> [email protected] >> >> https://puck.nether.net/mailman/listinfo/cisco-voip >> > >> > > > _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
