We have some Teradici Zero Clients, and began to have issues with them last year. We ended up hard coding them to 100/Full, and our issues went away.
We did have a different use case, as we were having the zero clients at the end of runs, not plugged into a device with what has to be less than a 14 foot cord. So I don't know. We were attributing it to some kind of attenuation on the cable plant (We didn't own the cable plant, nor did we have test results of it), and dropping to 100/Full cleared it up so we stopped investigating. We only had about 5 of the devices, and they are extremely static, so it wasn't worth the effort to investigate further. On Tue, Dec 12, 2017 at 10:54 PM, Nathan Reeves <[email protected]> wrote: > Interested to know if anyone's seen issues when connecting Teradici Zero > Clients through the switchport on Cisco Phones. In this case 8845 and 7841 > phones. > > Customer is moving to CUCM and has an established base of Zero Clients. > They're starting to see packet loss reported on their clients only when > connected to the network via the phones. Not previously noted packet loss > with their previous IP Phone (Siemens). > > Anyone know of any best practices / issues with this setup? > > Thanks > > Nathan > > _______________________________________________ > cisco-voip mailing list > [email protected] > https://puck.nether.net/mailman/listinfo/cisco-voip > >
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
