Here is the region information.
[cid:8f436bad-8c75-481a-999e-8abf58c113af] thank you very much for your help. ________________________________ From: Anthony Holloway <avholloway+cisco-v...@gmail.com> Sent: Wednesday, February 28, 2018 1:31 PM To: Hamu Ebiso Cc: cisco-voip voyp list Subject: Re: [cisco-voip] Need help configuring router for 911 with POTS Lines connected to FXO port on the router Regions are important for a working call flow, yes. However, regions only exist on CUCM, not on gateways. The way in which regions/codec selection could produce the issue your seeing is as follows: Dial Peer has g711ulaw on it CUCM SIP Trunk has Gateway-Region on it CIPC has Phone-Region on it Gateway-Region to Phone-Region is using 8kbps On Wed, Feb 28, 2018 at 12:30 PM Hamu Ebiso <hebiso2...@hotmail.com<mailto:hebiso2...@hotmail.com>> wrote: Region is not define in the config but CUCM. Is that what you need? That is the only config I have. and don't see any region defined in the gateway. thanks hamu ________________________________ From: Anthony Holloway <avholloway+cisco-v...@gmail.com<mailto:avholloway%2bcisco-v...@gmail.com>> Sent: Wednesday, February 28, 2018 11:19 AM To: Hamu Ebiso Cc: cisco-voip voyp list Subject: Re: [cisco-voip] Need help configuring router for 911 with POTS Lines connected to FXO port on the router But you didn't send all the information, because your output doesn't show the dial-peers. One method is to capture the output from "debug voip ccapi inout" and look for the following line "Outgoing Dial-peer=" You also didn't address the regions either. Can you send that too? On Wed, Feb 28, 2018 at 11:13 AM Hamu Ebiso <hebiso2...@hotmail.com<mailto:hebiso2...@hotmail.com>> wrote: I was just trying to give you all the information so that you will be able to see the whole picture. Regarding your questions, I don't know how to check that. ________________________________ From: Anthony Holloway <avholloway+cisco-v...@gmail.com<mailto:avholloway%2bcisco-v...@gmail.com>> Sent: Wednesday, February 28, 2018 10:45 AM To: Hamu Ebiso Cc: cisco-voip voyp list Subject: Re: [cisco-voip] Need help configuring router for 911 with POTS Lines connected to FXO port on the router That's interesting that I asked for the dial-peer config, and you sent everything but. Do you know how to confirm which dial-peer the gateway is using? On Wed, Feb 28, 2018 at 10:38 AM Hamu Ebiso <hebiso2...@hotmail.com<mailto:hebiso2...@hotmail.com>> wrote: Below is gateway configuration isdn switch-type primary-ni ! ! trunk group FXO_EM hunt-scheme sequential translation-profile incoming Incoming ! ! trunk group Local hunt-scheme sequential translation-profile outgoing outbound ! ! trunk group LD translation-profile outgoing outbound ! voice-card 0 dspfarm dsp services dspfarm ! ! voice call send-alert voice rtp send-recv ! voice service voip ip address trusted list ipv4 10.170.99.12 ipv4 10.44.50.14 ipv4 10.44.50.39 no ip address trusted authenticate clid substitute name clid network-provided allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip redirect ip2ip signaling forward unconditional fax protocol t38 nse force version 0 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711ulaw no fax-relay sg3-to-g3 modem passthrough nse codec g711ulaw sip bind control source-interface Loopback0 bind media source-interface Loopback0 session transport tcp min-se 360 session-expires 360 ds0-num header-passing error-passthru registrar server expires max 600 min 60 early-offer forced midcall-signaling passthru no call service stop ! ! voice class uri 10 sip host ipv4:10.x.x.x host ipv4:10..x.x.x host ipv4:10..x.x.x voice class codec 1 codec preference 1 g711ulaw codec preference 2 g729r8 ! voice class codec 2 codec preference 1 g711ulaw ! ! ! ! voice translation-rule 1 rule 1 /^208343\(....\)$/ /1208343\1/ ! voice translation-rule 9 rule 1 /5.../ /1208343\0/ ! voice translation-rule 10 rule 1 /^911/ /911/ rule 2 /^9911/ /911/ ! voice translation-rule 15 ! voice translation-rule 30 rule 1 /^911/ /911/ rule 2 /^9911/ /911/ rule 4 /^9\(011.*\)/ /\1/ rule 9 /^9\(.*\)/ /\1/ ! ! voice translation-profile Add1 translate calling 91 translate called 1 ! voice translation-profile Inbound translate called 1 ! voice translation-profile Strip9 translate called 10 ! voice translation-profile block_profile translate calling 15 ! voice translation-profile outbound translate calling 10 ! ! crypto pki token default removal timeout 0 ! ! ! ! license udi pid CISCO3845-MB sn FOC123128X5 license accept end user agreement archive log config hidekeys username admin privilege 15 password 7 105D1F0C username svuntbd privilege 15 secret 5 $1$vRxN$nu4JPZttcuPskPHoSdQZx. ! ! controller T1 0/0/0 shutdown cablelength long 0db ! controller T1 0/1/0 shutdown cablelength long 0db ! ! ! ! ! ! interface Loopback0 ip address 10.x.x.x 255.255.255.128 ! interface GigabitEthernet0/0 description uplink to Lan1 ip address 10.x.x.x 255.255.255.252 duplex auto speed auto media-type rj45 ! interface GigabitEthernet0/1 description uplink to Lan2 ip address 10.x.x.x 255.255.255.252 duplex auto speed auto media-type rj45 ! router ospf 1 auto-cost reference-bandwidth 10000 network 10.0.0.0 0.0.255.255 area 10.0.0.0 ! ip forward-protocol nd ! ! no ip http server no ip http secure-server !
_______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip