Ah. Neat. I didn’t catch that. We just bought a bunch of switches. I’ll have to ask about which model.
Sent from my iPhone On Jan 27, 2022, at 4:45 PM, Buchanan, James <[email protected]> wrote: CAUTION: This email originated from outside of the University of Guelph. Do not click links or open attachments unless you recognize the sender and know the content is safe. If in doubt, forward suspicious emails to [email protected] Hello, That example only applies to GigabitEthernet ports. The UXM switches don’t have GigabitEthernet ports. They have 2.5 Gigabit Ethernet ports and 10 Gigabit Ethernet ports. Thanks, James From: Lelio Fulgenzi<mailto:[email protected]> Sent: 27 January 2022 21:38 To: Lisa Notarianni<mailto:[email protected]> Cc: [email protected]<mailto:[email protected]> Subject: Re: [cisco-voip] ATA 186 question You might want to double check that. From this, 17.3, it shows 10 is a valid option. https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/17-3/configuration_guide/int_hw/b_173_int_and_hw_9300_cg/configuring_interface_characteristics.html#task_uw1_3wc_g1b Sent from my iPhone On Jan 27, 2022, at 3:45 PM, Lisa Notarianni <[email protected]> wrote: CAUTION: This email originated from outside of the University of Guelph. Do not click links or open attachments unless you recognize the sender and know the content is safe. If in doubt, forward suspicious emails to [email protected] We just began Cisco switch upgrade to 9300s and ran into an unexpected issue. We have many ATA 186s out there (about 100) and did not budget for replacement as we were gratefully approved for the massive overhaul of the switches. This ended up being an unforeseen glitch. We cannot get the ATA 186s to work on this switch with this IOS version: 1 65 C9300-48UXM 17.03.04 CAT9K_IOSXE INSTALL However, the 186s are working on this switch with this IOS version: 1 64 C9300-48P 16.9.5 CAT9K_IOSXE INSTALL I know it is not an apples to apples comparison but I was wondering if anyone had a workaround for the newer model/IOS. We believe the problem is that the ATA186s are hard coded at 10Mbps/half duplex. Even if we change the switch port parameter from 0x00000000 to 0x000000ff the ATA will not register. The switch port is also configured at duplex auto but the slowest we can make the port is 100Mbps. Is this not possible? I am hoping you Cisco geniuses have a solution 😊 Lisa Notarianni University of Scranton Telecommunications Engineer Infrastructure Services 800 Linden St. Scranton PA 18510 570.941.4325 _______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________ cisco-voip mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-voip
