Also, try using a dialer profile with dialer strings instead of dialer map
statements.. Put in both dialer strings for both numbers. I bet this will
fix the problem.
Cory
-----Original Message-----
From: Perusek, Richard [mailto:[EMAIL PROTECTED]]
Sent: Friday, May 12, 2000 8:27 AM
To: 'Peter Nguyen'; [EMAIL PROTECTED]
Subject: RE: Urgent Help
You might try adding 'no keepalive' to router B's configuration. If one end
of a dial up connection is expecting a keepalive and the other one isn't,
the connection will drop after the keepalive timer expires. I've experienced
the same situation you described, being able to ping for a few seconds and
then losing the connection, and it was caused by one end having a keepalive
and the end not.
> -----Original Message-----
> From: Peter Nguyen [SMTP:[EMAIL PROTECTED]]
> Sent: Thursday, May 11, 2000 3:33 AM
> To: [EMAIL PROTECTED]
> Subject: Urgent Help
>
> Hi all,
>
> Can you please check the below configuration and tell me where have I done
> wrong ?
>
> Basically, All I want to do is to use ppp multilink to increase throughput
> to 128k from two 64k ISDN.
>
> It behave rather strangely, If both routers were add the command ppp
> multilink, I can ping the remote site for a few seconds then it drops. If
> I
> takes ppp multilink out on one router, the connections established on one
> BRI subinterface, then eventually established the second interface ( as
> indicated by load-threshold specification)
>
> Please help !
>
> *** Router A ***
> interface BRI1/0
> description ISDN Connection to router B
> ip address 10.10.10.1 255.255.255.0
> no ip directed-broadcast
> ip accounting output-packets
> encapsulation ppp
> no keepalive
> dialer idle-timeout 2147483
> dialer map ip 10.10.10.2 name routerb broadcast
> dialer load-threshold 200 either
> dialer-group 1
> isdn switch-type basic-ts013
> priority-group 1
> no cdp enable
> ppp authentication chap
> ppp multilink
> hold-queue 10 in
>
> *** Router B ***
> description ISDN to Tatura
> ip address 10.10.10.2 255.255.255.0
> no ip directed-broadcast
> ip accounting output-packets
> encapsulation ppp
> dialer idle-timeout 2147483
> dialer map ip 10.10.10.1 name router a broadcast 0358335870
> dialer load-threshold 200 either
> dialer-group 1
> isdn switch-type basic-net3
> priority-group 1
> no cdp enable
> ppp authentication chap
> ppp multilink
> hold-queue 10 in
>
>
> Peter Nguyen
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
