if you are getting connected and losing connections almost immediately,
sounds like there must be some authentication problem on your authentication
server
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Krishnan Narayanan
Sent: 30 May 2000 13:50
To: '[EMAIL PROTECTED]'
Subject: cisco-windowsNT
I have a Cisco 26000 series router with a BRI
interface. I need to conenct this router on ISDN to a
Windows NT machine ( NT ver 4) which is conencted to
an OMNI 128 Zyxel TA.
I have configured the router as per CISCO docs .
The call lands on the TA fine. I get a message on the
router saying that the call is connected and then the
calll gets disconnected. Windows NT event viewer shows
the following message : 20070 , ppp authentication,
unable to converge. I have tried using PAP, CHAP as
well as MS CHAP. Dialin permissions in NT have also
been given.
Has a CISCO router been configured to Dial to an NT
machine ?? If so, can I have the configuration of the
same ? @
I would appreciate it if you could give me a config
for the above senario.
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
STANDARD DISCLAIMER: This message is confidential. You should not copy it or
disclose its contents to anyone. You may use and apply the information only
for the intended purpose. Internet communications are not secure and
therefore RM does not accept legal responsibility for the contents of this
message. Any views or opinions presented are only those of the author and
not those of RM. If this email has come to you in error please delete it and
any attachments.
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
