This has been resolved. By changing the configuration register to 0x2121, it
changed the baud rate to 19200. What needed to be done was to change the
baud rate on the terminal session and then change the config register back
to 0x2102 and then change the baud again to 9600. All is OK now
Thanks to all for the help!!
Andrew Larkins
-----Original Message-----
From: Flem [mailto:[EMAIL PROTECTED]]
Sent: 01 June 2000 12:56
To: [EMAIL PROTECTED]
Subject: Re: Cisco 3660 config register setting _ HELP!! URGENT
0x2121 ;
means that you will end up in bootmode and that you
ignore NVRAM .
Did you enter 0x2121 or just 2121 ?
If you entered just 2121 change the baudrate to 4800 .
flem
--- Andrew Larkins <[EMAIL PROTECTED]> wrote:
> I have loaded a newer image on the box, but have
> also changed the config
> register to 0x2121 by mistake. The console display
> now comes up garbled. How
> do I get this back to normal.???
>
> ___________________________________
> UPDATED Posting Guidelines:
> http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to
[EMAIL PROTECTED]
__________________________________________________
Do You Yahoo!?
Send instant messages & get email alerts with Yahoo! Messenger.
http://im.yahoo.com/
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
