Okay you all are correct and I was not clear enough. On 11.0 it does not
work on everything later it does work as Edgar described (invoking default
group 0) as shown below.
interface Ethernet0
ip address 1.0.0.1 255.0.0.0
no ip redirects
no ip route-cache
no ip mroute-cache
standby priority 110
standby preempt
standby authentication microdot
standby ip 1.0.0.2
ROUTER1#sh standby ethernet 0
Ethernet0 - Group 0
Local state is Init, priority 110, may preempt
Hellotime 0 holdtime 0
Hot standby IP address is 10.1.1.1 configured
Active router is unknown expired
Standby router is unknown expired
Standby virtual mac address is 0000.0c07.ac00
Now can I finish my lunch?
-----Original Message-----
From: McMasters, Eric [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, June 06, 2000 1:51 PM
To: 'Tom Thomas'; Mark; [EMAIL PROTECTED]
Subject: RE: HSRP Question
My interpretation of the examples that are presented are that the first
configuration will work, but will the second. Now, I am by no means an
expert, but I found in my handy dandy "Internetwork Troubleshooting
Handbook" where their example does not include the standby group number. I
also read that by not using a group number (ie 1, in this case) the standby
group would default to "0", and it would work. Could somebody please verify
this for me, because I would hate to propogate incorrect information.
Thanks.
Eric L. McMasters, CCNP/CCDA
OSSN - Sr. Network Engineer
Phone: 913.859.1986
PCS: 913.485.9734
Fax: 913.859.1234
-----Original Message-----
From: Tom Thomas [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, June 06, 2000 11:44 AM
To: Mark; [EMAIL PROTECTED]
Subject: RE: HSRP Question
It will not work :-)
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Mark
Sent: Tuesday, June 06, 2000 12:19 PM
To: [EMAIL PROTECTED]
Subject: HSRP Question
When configuring HSRP, Cisco gives the example of:
interface ethernet 0
ip address 1.0.0.1 255.0.0.0
standby 1 ip 1.0.0.4
standby 1 preempt
standby 1 priority 110
standby authentication microdot
The question is:
If the group number ie; standby "1", is not included such as the following,
what happens?
Example:
interface ethernet 0
ip address 1.0.0.1 255.0.0.0
standby ip 1.0.0.4
standby preempt
standby priority 110
standby authentication microdot
Thanks,
Mark
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
