I understood, you have to configure mls rp for the
mulitlayer swithing to work, right? why you do not
need mls rp when using MSFC? Is that because the RSM
is on board, it automatically does the multilayer
swithing to the MSFC card?
Thanks
Kent
--- Michael Rasmussen <tke
[EMAIL PROTECTED]> wrote:
> You shouldn't have to do anything else to route
> between just those two VLANs. Also just a side
> note. The mls rp ip command is not necessary since
> you are using the MSFC.
> ""Josh Youngman"" <[EMAIL PROTECTED]>
> wrote in message
>
002801bfcf35$caaaa2e0$[EMAIL PROTECTED]">news:002801bfcf35$caaaa2e0$[EMAIL PROTECTED]...
> i have a 6506 with a 48prt 10/100 blade i wish to
> configure 6 ports on one subnet (vlan2) and the rest
> on another (Vlan1) and use the supervisor to route
> between the two vlans. does anyone have any sample
> configs on how to do this. so far i have
> created the two vlans and assigned the ports. i
> then did a session 15:
> !
> router rip
> network 10.0.0.0
> !
> Interface vlan1
> set ip address 10.0.8.21 255.255.252.0
> mls rp ip
> !
> interface vlan2
> set ip add 10.0.12.21 255.255.252.0
> mls rp ip
> !
> !
>
> what else do i need here to route between the two
> vlans?
>
> thanks for any help.
>
__________________________________________________
Do You Yahoo!?
Yahoo! Photos -- now, 100 FREE prints!
http://photos.yahoo.com
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
