According to the "Catalyst 600 and 6500 Series Module Installation Guide",
page 1-8, if you are getting an orange status light during operation, it is
most likely due to an overtemperature condition. Make sure all fans are
working, ventilation is not blocked, etc. Also, we had 2 switch chassis
next to each other in a rack, so the warm exhaust was blowiung out of one
and directly into another. We moved the switches and the led went green.
The link to cco version of the module guide is:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/6000hw/mod_inst/01overvw.htm
From: Olden Pieterse <[EMAIL PROTECTED]>
Reply-To: Olden Pieterse <[EMAIL PROTECTED]>
To: "'[EMAIL PROTECTED]'" <[EMAIL PROTECTED]>
Subject: Cisco6509 with dead modules
Date: Tue, 18 Jul 2000 13:36:37 +0200
Hi there
Just quickly a question : I have a 6509 with a 48port ethernet card in it .
On the front the status lights are orange
If I do a show module x , then I get a status==other , all the rest are ok
.
I have enabled the module , put the power on and the works !
Is there anything else I can do to revive this module or can I safely assume
its going to be good as a door stopper/paper weight ?
Cheers
Olden Pieterse
MCP , CCNA , BCMSN , BSCN , BCRAN
Brainbench Certified CISCO Network Implementation Specialist
Technical Consultant
Mobile : +27 82 410 8621
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
