Hi Robert
2924s don't use set commands, they need to be put into global configuration
mode (conf t), and then interface configuration mode (int fa0/X) to apply
changes. Its not too dissimilar to router interface command sets. ctrl-z
exits config mode, and wr writes it away to nvram.
The set command from privileged exec will run an initial setup routine on
the switch.
Hope that helps,
Paul
Hello:
I am trying to set SPAN on my 2924 switch using command set span ....
My switch doesn't recognize this command. As matter of fact when I do
set ?
the only provided option is <CR>.
What's wrong? I was sure that 2924 can do span.
your help will be appreciated.
BTW, I am in privileged mode.
Thanks,
Robert
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
