Hi confused about the dialer pool. I have two dialer interfaces in which i am defining same dialer pool number and same dialer group number. Now i am configuring an ethernet interface for PPPoE. I am associating this ethernet interface with the dialer interface through the command pppoe-client dial-pool -number command.
The question is when i associate the dialer interface with the atm interface, now , which dialer interface will be taken for the ethernet interface association, as each dialer interface is having different ip addresses. The following are the configs nterface Ethernet6/0 no ip address half-duplex pppoe enable pppoe-client dial-pool-number 1 dial-on-demand ! ! interface Dialer0 ip address 2.2.2.2 255.0.0.0 encapsulation ppp dialer pool 1 dialer idle-timeout 180 either dialer hold-queue 100 dialer-group 1 no cdp enable ! ! interface Dialer10 ip address 3.3.3.3 255.0.0.0 encapsulation ppp dialer pool 1 dialer idle-timeout 180 either dialer hold-queue 100 dialer-group 1 no cdp enable Any help is appreciated. Thanks and regards Nag Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=66612&t=66612 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
