Yes you should see more. Are you sure you have ppp authenication enabled? For grins try debug isdn q931 and see if you get anything.
Dave James Gosnold wrote: > Dear all, on a Cisco 801 router I am entering > > #terminal monitor > #debug ppp negotiation > #logging monitor debug > #logging on > > RouterA#show log > Syslog logging: enabled (0 messages dropped, 0 messages rate-limit > 0 overruns) > Console logging: level debugging, 64712 messages logged > Monitor logging: level debugging, 668 messages logged > Logging to: vty1(13) > Buffer logging: level debugging, 64712 messages logged > Logging Exception size (2048 bytes) > Count and timestamp logging messages: disabled > Trap logging: level informational, 64346 message lines logged > > So when I initiate a call I am expecting all this debug output to appear as > per my CCNP study guide but instead all I get is: > > RouterA# > 8w2d: %ISDN-6-LAYER2UP: Layer 2 for Interface BR0, TEI 70 changed to up > 8w2d: %LINK-3-UPDOWN: Interface BRI0:1, changed state to up > 8w2d: BR0 IPCP: Install route to 192.168.10.2 > 8w2d: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state > to u > p > 8w2d: %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 01419925482 > RouterB > > As far as I can tell the only line of output included is the IPCP line that > I wouldn't normally get! > > Yet in my study guide there should be lines and lines of output showing all > the challenge/response and other various LCP info. > > Is it something to do with the 801 IOS? > > RouterA#show ver > Cisco Internetwork Operating System Software > IOS (tm) C800 Software (C800-Y6-MW), Version 12.2(8)T4, RELEASE SOFTWARE > (fc1) > TAC Support: http://www.cisco.com/tac > Copyright (c) 1986-2002 by cisco Systems, Inc. > Compiled Sat 04-May-02 11:28 by ccai > Image text-base: 0x000F5000, data-base: 0x0077F000 > > ROM: TinyROM version 1.4(1) > RouterA uptime is 8 weeks, 2 days, 23 hours, 12 minutes > System returned to ROM by power-on > System image file is "flash:c800-y6-mw.122-8.T4.bin" > > Cisco C801 (MPC850) processor (revision 1) with 44156K bytes of virtual > memory. > Processor board ID JAD062508M4 (78753280) > CPU part number 0x2101 > Bridging software. > Basic Rate ISDN software, Version 1.1. > 1 Ethernet/IEEE 802.3 interface(s) > 1 ISDN Basic Rate interface(s) > 4M bytes of physical memory (DRAM) > 8K bytes of non-volatile configuration memory > 8M bytes of flash on board (4M from flash card) > > Configuration register is 0x102 > > > > Thanks for any advice, James. -- David Madland CCIE# 2016 Sr. Network Engineer Qwest Communications 612-664-3367 I would rather have a German division in front of me than a French one behind me." --- General George S. Patton Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=66879&t=66867 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
