BGP load balancing can be done using BGP peering on loopback address .And you have to add static routes in
your routing table for loopback ip address and mention next-hop as serial links ip addresses/serial interface example: nei loopbackip remote-as asnumber nei loopbackip ebgp-multihop number and then ip route loopback ip 255.255.255.255 serialx ip route loopback ip 255.255.255.255 serialy hope this will help you Ramesh "Brian W." wrote: The way I've seen 2 paths used is by peering with a loopback interface and using neighbor peerip ebgp-multihop in the config. Brian ----- Original Message ----- From: "Azhar Teza" To: Sent: Tuesday, May 27, 2003 3:16 PM Subject: BGP Load Balance [7:69611] > If BGP route has two equal paths to the same destination, can it do load > balance by installing the command? maximum-paths 2 > > _______________________________________________ > Join Excite! - http://www.excite.com > The most personalized portal on the Web! Get Your Private, Free E-mail from Indiatimes at http://email.indiatimes.com Buy The Best In BOOKS at http://www.bestsellers.indiatimes.com Bid for Air Tickets @ Re.1 on Air Sahara Flights. Just log on to http://airsahara.indiatimes.com and Bid Now ! Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=69671&t=69611 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
