""- jvd"" wrote in message news:[EMAIL PROTECTED] > Hi, > > 802.1q is supported by Cisco on FastEthernet and GigabitEthernet, and not on > Ethernet. Check out:
moving to a new computer, and can't locate the beginning of this thread. sorry if this was covered previously. the 2610 and 11 will support dot1q trunking on the built in 10baseT ethernet ports. I believe this startrd with one of the earlier 12.1 IOS images. I also have done dot1q trunking of NM ethernet modules, both on the 36xx and 26xx platforms, again with an appropriate IOS image. If it was router ports of which you were speaking. Can't say as to whether or not there are 10baseT switch ports that support dot1q, although I "believe" you can do it on 35xx switches where the fastethernet port is forced to a 10megabit speed. > http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca801.html#xtocid18 > > ISL is supported by Cisco on Ethernet, FastEthernet and GigabitEthernet. > > Hope this helps. > Regards, Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=71080&t=70901 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
