Not in a good mood because I got a 703 on this test today (732 passing).
Hopefully, a little more review will get me over the hump.
However, I did have a frustrating experience with one of the new router
simulation questions - I wonder if anyone had a similar experience. I'll
keep
it general as to not disclose specific question contents. The problem was to
configure serial 0/0 on the router thru the console port:
Router>enable
password: cisco
Router#config t
Router(config)#interface serial 0/0
^
% Invalid input detected at '^' marker.
Router(config)#
I tried literally about two-dozen permutations & abbreviations of the above
command and the simulator would never let me into interface config mode. I
even
used help and tab and ?. I verified that I was in privileged mode and config
mode. I even checked if I was connected to the correct router.
I either did something blatantly wrong (which I guess is possible), or the
simulator went wack-o on me (less likely, but I believe still possible).
After 5 minutes, I gave up and moved on. The unfortunate part was I knew
exactly how to configure the interface, but I was not able to enter interface
config mode to complete the task. Thanks for letting me blow off some
steam!
dj
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=71765&t=71765
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
