You can use Cisco Error Message Decoder tool to interpret these kind of messages: http://www.cisco.com/kobayashi/support/tac/tools_trouble.shtml You need CCO login. Here is the error:
1. %GT96K_FEWAN-5-UNDERFLOW: Transmit underflow on int ... While a frame was being transmitted, the local buffer of the GT96K controller chip received insufficient data because data could not be transferred to the chip fast enough to keep pace with its output rate. Normally, such a prob lem is temporary, depending on transient peak loads within the system. *Recommended Action: * The system should recover. No action is required. *Related documents: *No specific documents apply to this error message. Hope it helps. /Nadeem Vikram JeetSingh wrote: >HI Joseba, > > >I have mostly seen the IP Fast Switching on the same interface in the >disabled mode by default, and you have forcefully enabled it. Try to disable >it and see the results. > >HTH > >Vikram > > >-----Original Message----- >From: Joseba Izaga [mailto:[EMAIL PROTECTED] >Sent: Saturday, July 19, 2003 6:26 AM >To: [EMAIL PROTECTED] >Subject: Error on an interface FastEthernet of a router 3745 [7:72610] > > >Hi, > >Do you now the reason of the folowing message: > >11:31:40: %GT96K_FEWAN-5-UNDERFLOW: Transmit underflow on int >FastEthernet0/0 >11:31:40: %GT96K_FEWAN-5-UNDERFLOW: Transmit underflow on int >FastEthernet0/0 > > >This is configuration I have on the interface > >interface FastEthernet0/0 > ip address 63.80.132.16 255.255.255.0 > ip route-cache same-interface > ip policy route-map mail > speed 100 > full-duplex > >Regards, > >Joseba Izaga Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=73139&t=73139 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
