if you are talking about NM-16A, then
1. async mode only, it does not support leased line. uou can use modem.
2. yes!
3. using console cable is ok. i get this work in two WIC-1DSU-56K4
hope this help
regards,
Fanglo
Ravi Kumar wrote:
> hi friends
>
> I am going to buy 2 no. of 2610 routers with 2 port sync/async card.
>
> my queries are
>
> 1) will this card support both leased lines and ordinary dial up lines at a
> time (one port for leased line and another port for dial up logins)
>
> 2) if it support PSTN dialup lines, how many it will support at a time??
> i.e. can i fix 8 port octal cable into one of the interface so that i can have
> 8 simultaneous logins from remote locations???
>
> 3) i need CSU/DSU cable for back to back connectivity between 2 routers for
> simulating WAN environment. where do i get that cable? will the same cable
> which i am using for 2500 series routers work??
>
> your help in this regard is highly apprecaited.
>
> bye
> ravi kumar B.
>
> ____________________________________________________________________
> Get free email and a permanent address at http://www.netaddress.com/?N=1
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
