#Config T
No Partition Flash
^Z
When you have two sticks, the default is the partition of them...
Good Luck !!!
Phil
----- Original Message -----
From: "Bob & Karen Timmons" <[EMAIL PROTECTED]>
To: "Ashfaq Aslam" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Friday, September 01, 2000 10:26 PM
Subject: Re: Memory question - pls help !!
> You have to partition the Flash to make it one big (virtual) flash.
>
> Check out :
>
http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/112cg_cr/1cb
> ook/1csysim.htm#xtocid2402062
> (watch the word wrap)
>
> Bob
>
> ----- Original Message -----
> From: "Ashfaq Aslam" <[EMAIL PROTECTED]>
> Newsgroups: groupstudy.cisco
> To: <[EMAIL PROTECTED]>
> Sent: Friday, September 01, 2000 4:54 PM
> Subject: Memory question - pls help !!
>
>
> > Hi there,
> >
> > I have just installed 2 X 8MB Flash modules in 2503 Router and when I do
> > "Show Version" it shows up as two seperate 8MB Flashes instead of 16MB.
> > E.g.
> >
> > cisco 2500 (68030) processor (revision F) with 16384K/2048K bytes of
> > memory.
> > Processor board ID 04594752, with hardware revision 00000000
> > Bridging software.
> > X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
> > Basic Rate ISDN software, Version 1.0.
> > 1 Ethernet/IEEE 802.3 interface.
> > 2 Serial network interfaces.
> > 1 ISDN Basic Rate interface.
> > 32K bytes of non-volatile configuration memory.
> > 8192K bytes of processor board System flash partition 1 (Read/Write)
> > <<***************???***
> > 8192K bytes of processor board System flash partition 2 (Read/Write)
> > <<***************???***
> >
> > Configuration register is 0x2142
> >
> > Router#
> >
> > Does anyone know how to make it come up as 16MB?
> >
> > Thanks for your help !!!
> >
> > Rgds,
> > Ash
> >
> > ___________________________________
> > UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> > FAQ, list archives, and subscription info: http://www.groupstudy.com
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> >
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
