Is there a tool or white paper that explains the capabilities and enhancements of the different software versions? (I.e. IP, IP+, Enterprise...) Thanks. ----Original Message Follows---- From: "whatshakin" <[EMAIL PROTECTED]> Reply-To: "whatshakin" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Subject: Re: ISL on sub-if Date: Tue, 5 Sep 2000 00:09:52 -0700 I just tried 12.0.3T3 Enterprise Plus and 12.0.4T IP Plus on a 2621 and neither version has an encapsulation command available under the interface config mode. Both of these run on 8 flash and 32 Dram. I finally found it on a 11.3 IP Plus IPSec 56 image which also requires 8 flash and 32 Dram. I looked on the IOS software upgrade planner, the Software Compatibility Matrix and various IOS release notes looking for a feature set that is not so difficult to get (expensive) but none of them gave me any specifics to work with. I am going to check the 12.0.4T version of IP Plus IPSec 56 ( 8flash/32dram) tomorrow just for the hell of it, and see whether that image has it (almost guaranteed). I will post the results. ----- Original Message ----- From: Jared Carter To: [EMAIL PROTECTED] Sent: Saturday, September 02, 2000 9:28 AM Subject: ISL on sub-if Group- I have 2 2924 and a 2620 I am trying to practice routing between VLANs. The trunk between the switches is okay. When I create the sub-if on the router and try to run encap isl 2, it barks at me that this is an unrecognized command... ie "encapsulation" is not a valid command. I am running 12.0(3)T3 code on the router. Am I just missing something obvious? Thanks /Jared _________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com. Share information about yourself, create your own public profile at http://profiles.msn.com. ___________________________________ UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html FAQ, list archives, and subscription info: http://www.groupstudy.com Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
