I think that the Etherchannel configuration is working correctly. After
placing two ports in a port group, oneof the ports shows that STP is
"disabled" and the other shows that it is in a forwarding state. I believe
this is correct and that the switch only allows one of the ports in the
group to participate in STP. Please correct me if I am mistaken.
Thanks,
Lonnie
""Lonnie Paschall"" <[EMAIL PROTECTED]> wrote in message
8qdf8r$s5r$[EMAIL PROTECTED]">news:8qdf8r$s5r$[EMAIL PROTECTED]...
> I have a 2916XL that is connected to a compaq server with two NC3130 NIC
> cards and is configured for Cisco Etherchannel. I placed the two
contigous
> ports in a port group. When I look at the switch both interfaces are up,
the
> switch shows that they are both in group 1 but one port is in blocking
mode
> while the other is forwarding. Shouldnt they both be in forwarding mode? I
> am not sure if the Etherchannel is working. I have the same sort of
problem
> when I try to connect a 1900XL EN to the 2916 switch via etherchannel (two
> bundles), one port always goes into blocking mode or shows disabled .
>
> Thanks,
>
> Lonnie
>
>
> **NOTE: New CCNA/CCDA List has been formed. For more information go to
> http://www.groupstudy.com/list/Associates.html
> _________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
