On Mon, 2 Oct 2000 [EMAIL PROTECTED] wrote:
> In a message dated 10/2/00 12:04:33 AM Eastern Daylight Time,
> [EMAIL PROTECTED] writes:
>
>
> << Does anyone know how to configure Subinterfaces in Frame-Relay between 2
> Cisco 2500 Routers? A short example will do...
> >>
>
> If you meant to create one then here you go...quite simple actually:
>
> conf t
> int s0.x
Best to first set encaps frame-relay on the physical interface.
And, you'll need to specify the sub-inteface as point-to-point or
multipoint.
So,
# conf t
(config)# int s0
(config-if)# encaps frame [ietf]
(config-if)# [LMI type, no shut, controller t-1 stuff, etc.]
(config-if)# int s0.16 point-to-point
(config-subif)# ip address www.xxx.yyy.zzz nnn.mmm.nnn.mmm
(config-subif)# frame-relay interface-dlci nn
I usually set the subinterface number equal to the local DLCI just to
make things easy to keep track of.
Note that deleting subinterfaces completely requires a reload. You can
delete in the config but they'll still be there marked "deleted" until
you boot the box.
--
Jay Hennigan - Network Administration - [EMAIL PROTECTED]
NetLojix Communications, Inc. NASDAQ: NETX - http://www.netlojix.com/
WestNet: Connecting you to the planet. 805 884-6323
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
