RE: OT : HP Openview to monitor router and switch

[Hitesh Pathak (CSD-BBYRO-RTSG)]

if you are using RMON then check for the supported version on both
switch/router.
good luck
HP


> -----Original Message-----
> From: Lam Hay Tak [SMTP:[EMAIL PROTECTED]]
> Sent: October 16, 2000 2:46 PM
> To:   Benny Leong (HTHK - Senior Engineer II - iServices Development,
> NNSD)
> Cc:   '[EMAIL PROTECTED]'
> Subject:      Re: OT : HP Openview to monitor router and switch
> 
> Probably the SMNP MIB version on both of them were not much. Try to check
> the version..
> hope it helps.
> 
> On Mon, 16 Oct 2000, Benny Leong (HTHK - Senior Engineer II - iServices
> Development, NNSD) wrote:
> 
> > I need to monitor Cisco router 7206 and Catalyst 5509 using HP Openview
> > network management station.  I have loaded the CISCO-GENERAL-TRAPS.my,
> > however, the station cannot interpret the trap generated by the routers.
> > What goes wrong ? 
> > 
> > 
> > _________________________________
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> > 
> 
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]