Thanks! That would explain why it never made a difference. Cisco's info on
it is a bit vague. I got this from the Cisco CD:
dialer enable-timeout
To set the length of time an interface stays down after a call has completed
or failed and before it is available to dial again, use the dialer
enable-timeout interface configuration command. To return to the default
value, use the no form of this command.
dialer enable-timeout seconds
no dialer enable-timeout
Syntax Description
seconds
Time in seconds that the Cisco IOS software waits before the next call can
occur on the specific interface. Acceptable values are positive, nonzero
integers.
This value must be greater than the serial pulse interval for this
interface, set via the pulse-time command.
Default
15 seconds
Command Mode
Interface configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 10.0.
This command applies to inbound and outbound calls.
If your phone lines are often busy or down, you might want to enforce a
certain period of time before the system repeats an attempt to make a
connection with a remote site. Configuring this timeout can prevent outgoing
lines and switching equipment from being needlessly overloaded.
Louie
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of
Mark Vicuna
Sent: Wednesday, October 25, 2000 3:09 AM
To: Louie Belt; [EMAIL PROTECTED]
Subject: Re: OSPF Demand Circuit...
Louie,
dialer enable-timeout is used for callback.
hth,
Mark.
At 12:03 AM 10/25/00 -0500, Louie Belt wrote:
>While configuring and OSPF demand circuit over ISDN, I noticed that the
ISDN
>link would disconnected and immediately reconnect - because the change in
>ospf topology was triggering and LSA flood - forcing the ISDN line to
>reconnect. However, the dialer enable-timeout setting was at it's default
>of 15 seconds so the ISDN link should have been forced to wait 15 seconds
>before attempting to reconnect (and thereby giving the LSA flood time to
>pass). However, this did not happen. No matter what I set the dialer
>enable-timeout to, the redial happened immediately.
>
>Question: What am I missing? (or mis-understanding)
>
>Thanks in advance!
>
>Louie
>
>
>
>
>
>
>_________________________________
>FAQ, list archives, and subscription info:
>http://www.groupstudy.com/list/cisco.html
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
