http://www.cisco.com/warp/public/701/60.html
http://www.cisco.com/warp/public/556/index.shtml
Check for "overload". Or the following cut from the first URL above.
Translating to interface's address:
As a convenience for users wishing to translate all inside addresses to
the address assigned to an interface on the router,
the NAT code allows one to simply name the interface when configuring
the dynamic translation rule:
ip nat inside source list <number> interface <interface> overload
If there is no address on the interface, or it the interface is not up,
no translation will occur.
Example:
ip nat inside source list 1 interface Serial0 overload
-----Original Message-----
From: Circusnuts [mailto:[EMAIL PROTECTED]]
Sent: Sunday, October 29, 2000 7:12 PM
To: [EMAIL PROTECTED]
Subject: Configuring PAT
Anyone have experience with PAT. I've researched things on the CCO & found
very little information. I found that a minimum of 11.3(9)T is required,
but have seen little else as far as configs. I am planning to use this for
a dual Ethernet 2500, on a cable modem system...
Thanks All !!!
Phil
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
