As I understand it, you can't use a 675 to connect to PacBell, because
of the DSLAMs that they use. The 675 uses rate-adaptive CAP encoding (I
believe GTE and US West use these DSLAMS), PacBell uses the Discreet
MultiTone (DMT) ANSI T1.413 Issue 2 standard available on the 677 and
the 827.
Of course Cisco never mentions this, PacBell never mentions this, and
its like pulling teeth to get the applicable information. I got this
far by quizzing the PacBell help desk on who builds the DSLAMs (Alcatel)
then calling Alcatel to see what encoding I need to use.
Hope this helps,
Jeremy
Andre Fecteau wrote:
> Hello,
>
> I'm trying to get my Cisco 675 to run and I can't get it to synch up.
> The light on the WAN side keeps blinking. Does anyone have any idea
> what I can do to get this to work? The eth0 works, but WAN0 just
> keeps blinking.
>
> If I have the upload and download speed set faster than what I'm
> supposed to get will this cause it not to work? Or will it just
> receive the amount it's supposed to (auto)? I set my VPI/VCI to 0,
> 35. Does anyone have any tips on what to change or look for to get it
> working? My service provider is Pacbell, not that this matters. I
> got 384D/128U. I have a 5 static addresses.
>
> Does anyone have maybe a example configuration I can have? You can
> put x's where the IP's are or something!
>
> Help!!!
> Andre
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
